Door Seals

Door Seals







Door seals are equipped at factory with sealant, applied to door flange and then rolled on.

NOTE:
- During removal of seal, sealant is distributed on interior side of seal and flanks are bent up easily. If seal is re-installed, sealing performance and proper seating are no longer guaranteed.
- For this reason, every completely removed seal must be replaced with a so-called Hammer-stroke seal.
- For partially removed seals, seal flanks must be pressed together before installation.

Door seals, assembly overview







1 - Door inner seal, 4-door
- To install seal, begin in upper radius of door cut out.

2 - Door inner seal, 2-door
- To install seal, begin at B-pillar trim

3 - Internal door seal
4 - Auxiliary seal
- Material - TPE
- Auxiliary seal cannot be removed without destroying it

5 - Outer door seal, 4-door
6 - Clip
- Inserted into door seal

7 - Clip
- Inserted into door seal

8 - Outer door seal, 2-door

NOTE:
- Trim must be removed in order to remove door seals.
- Depending on space arrangement, it may be necessary to remove instrument cluster as well.