Assembly Overview

Brake Pedal, Assembly Overview

Caution!
^ The brake pedal travel must not be restricted by additional floor coverings.

Note:
^ Grease all mountings before installing with grease, Part No. G 000 602.

1. Mounting bracket
2. Self-locking hex nut, 20 Nm (15 ft. lbs.)
3. Brake light switch
^ Before installing brake light switch, connect brake pedal to brake booster push rod. Refer to Brake pedal to brake booster, disconnecting and connecting.
^ Before installing pull plunger out completely
Installing:
- Push brake pedal down as far as possible by hand
- Guide switch through mounting hole (only fits in one position) and secure by turning 90° clockwise
- Release brake pedal
- Connect wiring connector
- Check function of brake lights
4. Accelerator pedal
5. Hex bolt
6. Brake pedal
7. Pad
8. Self-locking hex nut, 20 Nm (15 ft. lbs.)
9. Bushing
10. Pivot pin