Shift Interlock Cable: Adjustments

Adjusting
- Loosen bolt -6-.
- Make sure it is possible to move support bracket -3- by hand in direction of arrow-5-.
- Move steering column down and to rear.
- Install 3352 A adjusting gauge (item -4-) between locking lever and locking cable eye.
- To compensate for play, pull support bracket in direction of arrow -5- up to stop and tighten bolt -6- to 10 Nm (7 ft. lbs.).
- Remove adjusting gauge.
- Check operation of ignition key withdrawal lock after each locking cable adjustment. Testing and Inspection
- Install steering column switch.
- Install steering wheel with airbag.
- Install center console and extension.
- Install selector lever handle. Shifter A/T
- Connect battery Ground (GND) strap.
- Input correct coding for anti-theft radio (if equipped).