Up to 09/2000

Lock carrier and front bumper reinforcement, removing and installing up to 09/00


Removing






- Remove noise insulation.
- Remove turn signals Front Turn Signal and Side Marker Light Housing


- Disconnect bowden cable -6- from coupling and disconnect electrical harness connectors.
- Remove front bumper and remove side guide pieces from fender. Front Bumper Cover, Removing and Installing
- Disconnect hoses for charge air cooler (only corresponding engine versions)
- Drain coolant and disconnect coolant pipes. Service and Repair
- Remove condenser from lock carrier. Service and Repair
- Remove hydraulic oil cooler from lock carrier.
- ATF lines must be removed for vehicles with automatic transmission with ATF cooler Service and Repair

CAUTION! If lines for A/C system and/or for coolant are disconnected, engine must no longer be started.

Note: Do not hang condenser and hydraulic oil cooler on hoses. Do not kink condenser and oil lines/hoses.

Installing:

Installation is reverse of removal

- Make sure that all plug and hose connections are connected when re-assembling.
- Check ATF level and top off
- Align lock carrier at longitudinal members and between fenders.
- Adjust headlights. Adjustments