Trunk / Liftgate Latch: Service and Repair

Rear Lid Lock, Removing And Installing (Jetta)







1 - Lock cylinder housing
2 - Handle
- Removing
- Remove bolt, disconnect connector for switch and remove handle from lid.

3 - Switch for rear lid release E165
4 - Rear Lid
5 - Lock
- Removing
- Disconnect connector from lock.

6 - Hex nut
- 7 Nm

7 - Actuator lever with linkage clip
8 - Motor for rear lid release V139
- Removing
- Disconnect connector from motor.
- Remove nuts and remove carrier plate.
- Remove motor for rear lid release from carrier plate.

9 - Actuator lever
10 - Hex nut
- 7 Nm

11 - Actuator rod
12 - Support bracket
13 - Actuator rod
14 - Bolt
- 7 Nm