Trunk / Liftgate Handle: Service and Repair

1 - Lock cylinder housing
2 - Handle
- Removing:
- Remove lock trim.
- Remove bolt -14-.
- Disconnect wiring for switch -3-.
- Remove handle from lock.
3 - Rear lid release switch
4 - Rear lid
5 - Lock
6 - Hex nut
- 7 Nm (62 in. lb)
7 - Linkage lever
8 - Rear lid release motor
9 - Linkage lever
10 - Hex nut
- 7 Nm (62 in. lb)
11 - Actuator rod
- Press linkage lever -9- against stop on motor -8- and hook in actuator rod without tension
12 - Support bracket
13 - Actuator rod
- Press linkage lever -9- against stop on motor -8- and hook in actuator rod without tension
14 - Bolt
- 7 Nm (62 in. lb)
15 - Bolt
- 7 Nm (62 in. lb)
16 - Rear lid release switch