III-Free Wheel and Reverse Gear Brake, Removing and Installing

III-Free wheel and reverse gear brake -B1-, removing and installing
Refer to Overview.
Disassembling transmission.
Assembling. Disassembling and Assembling





1. Circlip
- For supporting tube -B2-
- Installation position. Circlip open ends must face free wheel retaining wedge
2. Circlip
- For freewheel
- Installation position. Circlip open ends faces free wheel retaining wedge
3. Free wheel with -B1- piston
- Before removing free wheel, remove valve body and sealing plugs. Refer to Valve Body; Service and Repair.
- Disassembling and assembling.
4. Dished spring
- Install with convex side facing free wheel
5. Pressure plate -B1-
- Install with flat side facing plates
- Spare part must comply with transmission code letters
6. Inner plate, -B1-
- Quantity of inner plates -B1-.
- Soak plates in ATF for 15 minutes before installing
7. Outer plate, -B1 -
- Quantity of outer plates -B1-.
8. Shim
- Determining thickness. Refer to Adjustments. Adjustments
9. Transmission housing with planet carrier installed