Power Trunk / Liftgate Lock Actuator: Service and Repair

1 - Securing clip
2 - Handle
3 - Actuator securing bolt
- Release and tighten with socket T 10010
4 - Central locking actuator
- Removing:
- Disconnect connector on actuator.
- Unscrew actuator with special tool T 10010 and unhook from rear lid
5 - Pull rod
6 - Torx(R) screw
7 - Operating rod
- Press relay lever -11 - against stop and insert operating rod without tension
8 - Lock cylinder housing
9 - Lock
10 - Countersunk bolt
- 20 Nm (15 ft lb)
11 - Relay lever