01V Automatic Transmission

Locking Cable, Removing And Installing

Removing





- Obtain radio code.
- Move selector lever to position "2"
- Disconnect ground (GND) strap on battery.
- Remove selector lever handle. Shifter A/T
- Remove center console and extension.
^ Removing steering wheel with airbag.
^ Removing steering column switch.
^ Removing steering column trim
- Turn ignition key to "ignition on" position.
- Move selector lever to position "P"
- Lift locking clip on locking device -1- and pull locking cable out from ignition/starter switch.
- Remove cover with guide.
- Unclip locking cable from securing spring on mounting bracket by lifting securing spring slightly.
- Release locking cable from cable tie -2- and take out.

Installing
- Route locking cable free of kinks.
- Turn ignition key to "ignition on" position.
- Connect locking cable to ignition/starter switch.
- Ensure locking device -1- engages.
- Secure locking cable to airbag sensor with cable tie -2-.
- Turn ignition/starter switch to locked position ("ignition off").
- Move selector lever to position "P"
- Clip locking cable onto securing spring in mounting bracket.
- Hook locking cable support bracket -3- into selector mechanism and locking cable eye into lever (for locking cable).