01V Automatic Transmission

Adjusting
- Loosen bolt -6-.
^ Must be able to move support bracket -3- by hand in direction of arrow -5-.
- Move steering column down.
- Position setting bar 3352 A -item 4- between lever (for locking cable) and locking cable eye.
- Pull locking cable in direction of arrow -5- and tighten bolt -6- to 10 Nm (7 ft. lbs.).
- Remove setting bar.
- Check ignition lock key withdrawal after each adjustment of locking cable. Testing and Inspection
^ Installing steering column trim
^ Installing steering column switch.
^ Installing steering wheel with airbag.
^ Removing/installing center console and extension.
- Install selector lever handle. Shifter A/T
- Connect battery ground (GND) strap.
- Activate radio code.