Cleaning

ATF lines and ATF cooler, cleaning
If ATF is dirty, clean oil cooler and ATF lines with compressed air (max. 10 bar) before installing transmission.

WARNING: Wear Protective glasses.

- Remove ATF line brackets on transmission and engine.





- Remove bolt-2-.
- Remove ATF lines from transmission.
- Connect hose to ATF line -A- and secure with hose clamp. Hang other end of hose in suitable container.





- Blow through ATF line -B- several times with a compressed air gun.
- Change hose from ATF line -A- over to ATF line -B- and repeat sequence.
- Secure ATF lines again.
- Check and top up ATF level.