Sunroof With Glass Panel, Assembly Overview

Sunroof With Glass Panel, Assembly Overview







1 - Glass panel for sunroof (one-piece safety glass)
2 - Panel seal
- Adjusting panel seal.
- Seal joint at center in rear area.
- Before installing, treat sealing channel of panel seal with lubricant (soap solution).

3 - Sun protection
4 - Water channel
- Removing glass panel for sunroof.
- Press clips forward to open. Pull water channel up and out.

5 - Slotted guide rail
6 - Trim frame
- Removed together with slotted guide rail

7 - Upper trim
8 - Lower trim
9 - Center guide
- Removed together with slotted guide rail

10 - Front guide
- Removed together with slotted guide rail

11 - Wind deflector
12 - Countersunk screws (micro-encapsulated)
- Always use new countersunk screws.
- 3.5 Nm

13 - Electrical drive motor
- Checking drive motor ("0" position).

14 - Hex wrench for emergency operation
- Clipped in on electric drive motor.

15 - Installation unit
- U-frame (with guide channels), if necessary use special grease G 000 450 02 exclusively to grease guide channels, otherwise functions cannot be guaranteed.

16 - Spring plate
17 - Pinion cover
18 - Water drain hoses
- Cleaning water drain hoses.