Spring, Rear

Rear

NOTE: Directly below the component legend are the Fig. numbers. Please refer to these for information regarding removal and installation instructions.






1 Shock Absorber
- Need not be replaced if only slight traces of oil are visible
- Removing/installing, applications, refer to parts part supplier

2 Lower Spring Seat
- Installation position, refer to Fig. 2

3 Insulator

4 Circlip

5 Coil Spring
- Removing/installing, applications, refer to parts supplier

6 Protective Cap

7 Protective Tube

8 Bump Stop

9 Spring Seat
- Installation position, refer to Fig. l

10 Washer

11 Spring Support

12 Spacer

13 Rubber Lower Mounting

14 Nut
- Tighten to: 15 Nm (11 ft. lbs.)





Fig. 1 - Spring Seat, Installation Position





Fig. 2 - Lower Spring Seat, Installation Position

CAUTION: The spring seat must be installed so that the holes -a- align with the bushing in the shock absorber eye -2- or the spring seat -1- could interfere with the tire.