Intermediate Pipe

LEGEND
1 Nut
2 Locking Clamp
3 Intermediate Pipe
4 Bracket
5 Bolt
6 Front And Rear Muffler
7 Dimension -c-
8 Marking For Double Clamp (to Be Used When Replacing One Of The Mufflers)
9 Cutting Point
10 Dimension -b-
11 Marking
12 Retaining Ring
13 Bracket
14 Nut
15 Bracket

NOTE: During removal and installation procedures, refer to the component location illustration above and component notes below.

COMPONENT NOTES
Nut (1)
- Tighten to: 40 Nm (30 ft. lbs.).

Bolt (5)
- Tighten to: 25 Nm (18 ft. lbs.).

Front And Rear Muffler (6)
- Available as separate replacement parts.
- Cut connecting pipe at right angle at point -10- inset-A-.
- Connect front and rear muffler with double clamp.
- Slide double clamps toward mark -8- inset-B-.

Dimension -c- (7)
- Approximately: 10 mm (0.39 inch).

Marking For Double Clamp (to Be Used When Replacing One Of The Mufflers (8)
- Marked three times on pipe circumference.

Dimension -b- (10)
- Approximately: 5 mm (0.20 inch).

Marking (11)
- Marked three times on pipe circumference.

Nut (14)
- Tighten to: 20 Nm (15 ft. lbs.).