Driveplate, Removing and Installing

Driveplate, removing and installing

Removing






- Fasten VW558 flywheel lock adapter to driveplate with hex bolt M8x45.
-Install two M1O hex nuts between VW558 and driveplate.

Position for W558:

A - to loosen mounting bolts

B - to tighten mounting bolts

Installing






- Install driveplate using washer with cut-outs -1-.
- Install new bolts -3- and tighten to 30 Nm (22 ft lb).






- Check dimension -a- at three points and calculate average value.

- Specified value: 19.5-21.1 mm (0.768-0.831 in.)

If NOT:






- Remove driveplate and install shim -2-.
- Tighten bolts -3- to 30 Nm (22 ft lb).
- Tighten bolts -3- to 60 Nm (44 ft lb) plus 1/4- turn (90 °).