One-Way Clutch With Plastic Cage For Rollers and Springs

FIGURE 6 - PLASTIC CAGE SEGMENTS:

FIGURE 7 - SPRINGS AND ROLLERS, INSTALLING:

FIGURE 8 - INSTALLATION POSITION OF CAGE:

FIGURE 9 - SECURING CAGE:

assembling segments Fig. 6
installing springs and rollers Fig. 7
installation position of cage Fig. 8
securing cage Fig. 9


Note

New plastic cage can be service-installed in earlier transmissions. Circlips previously used have been discontinued and can not be used with plastic cage.

FIGURE 6 - PLASTIC CAGE SEGMENTS:

- assemble 10 segments to form a ring

FIGURE 7 - SPRINGS AND ROLLERS, INSTALLING:

^ spring tab (arrow) toward roller

FIGURE 8 - INSTALLATION POSITION OF CAGE:

-insert cage into outer ring from below (direction of arrow A)

^ small ledge (1) at top
^ large ledge (2) at bottom

FIGURE 9 - SECURING CAGE:

- turn in direction of arrow