Removal

AXLE AND DIFFERENTIAL: STEERING KNUCKLE: REMOVAL; 2013 MY Corolla [07/2012 -]

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. REMOVE FRONT WHEEL

2. REMOVE FRONT AXLE HUB NUT (for 2AZ-FE) Removal

3. REMOVE FRONT AXLE HUB NUT (for 2ZR-FE) Removal

4. SEPARATE FRONT SPEED SENSOR (for TMC Made) Removal

5. SEPARATE FRONT SPEED SENSOR (except TMC Made) Removal

6. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY Front Axle Hub

7. REMOVE FRONT DISC Removal

8. SEPARATE TIE ROD END SUB-ASSEMBLY Removal

9. SEPARATE FRONT LOWER SUSPENSION ARM Removal

10. REMOVE FRONT AXLE ASSEMBLY Removal

11. REMOVE FRONT LOWER BALL JOINT Removal

12. REMOVE FRONT AXLE HUB HOLE SNAP RING Removal

13. REMOVE FRONT AXLE HUB SUB-ASSEMBLY Removal

14. REMOVE FRONT DISC BRAKE DUST COVER Removal

15. REMOVE STEERING KNUCKLE

(a) Place the front axle hub bearing inner race (outside) on the front axle hub bearing.

(b) Using SST and a press, remove the front axle hub bearing from the steering knuckle.





SST : 09223-15020

SST : 09387-02010

SST : 09950-60010

09951-00640

SST : 09950-70010

09951-07100