Installation

DOOR LOCK: UNLOCK WARNING SWITCH: INSTALLATION; 2013 MY Corolla [07/2012 -]

1. INSTALL UNLOCK WARNING SWITCH ASSEMBLY

(a) Make sure that the ignition switch lock cylinder assembly is in the ACC position.





(b) Install the ignition switch lock cylinder assembly to the steering lock sub-assembly.

(c) Make sure that the ignition switch lock cylinder assembly is securely installed.

2. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY Reassembly

3. INSTALL SOLENOID WIRE (for Automatic Transaxle) Reassembly

4. INSTALL KEY INTERLOCK SOLENOID Reassembly

5. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (for Manual Transaxle) Reassembly

6. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (for Automatic Transaxle) Reassembly

7. INSPECT STEERING LOCK OPERATION Steering Column Assembly

8. INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY Reassembly

9. INSTALL NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY Installation

10. INSTALL STEERING POST ASSEMBLY (for 2ZR-FE) Installation

11. INSTALL STEERING POST ASSEMBLY (for 2AZ-FE) Installation

12. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

13. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY Installation

14. INSTALL STOP LIGHT SWITCH ASSEMBLY Installation

15. INSTALL NO. 3 AIR DUCT SUB-ASSEMBLY Installation

16. INSTALL INSTRUMENT PANEL SUB REINFORCEMENT Installation

17. INSTALL COLUMN HOLE COVER SILENCER SHEET Installation

18. INSTALL TRANSPONDER KEY AMPLIFIER Installation

19. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

HINT
Refer to the instructions for Installation of the upper instrument panel Installation.

20. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY Installation

21. INSTALL UPPER STEERING COLUMN COVER Installation

22. INSTALL LOWER STEERING COLUMN COVER Installation

23. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

24. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

25. ADJUST SPIRAL CABLE Installation

26. INSTALL STEERING WHEEL ASSEMBLY Installation

27. INSTALL STEERING PAD Installation

28. INSTALL LOWER NO. 3 STEERING WHEEL COVER Installation

29. INSTALL LOWER NO. 2 STEERING WHEEL COVER Installation

30. INSPECT STEERING WHEEL CENTER POINT

31. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

32. INSPECT STEERING PAD Installation

33. INSPECT SRS WARNING LIGHT

Diagnosis System