Removal

BRAKE SYSTEM (OTHER): BRAKE BOOSTER: REMOVAL; 2013 MY Corolla [07/2012 -]

NOTICE:
Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.

1. REMOVE NO. 2 CYLINDER HEAD COVER (for 2ZR-FE) Removal

2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY (for 2ZR-FE) Removal

3. REMOVE AIR CLEANER CASE (for 2ZR-FE) Removal

4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (for 2AZ-FE) Removal

5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE (for 2AZ-FE) Removal

6. REMOVE AIR CLEANER CASE (for 2AZ-FE) Removal

7. REMOVE FRONT WIPER ARM HEAD CAP Removal

8. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH Removal

9. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH Removal

10. REMOVE HOOD TO COWL TOP SEAL Removal

11. REMOVE CENTER NO. 1 COWL TOP VENTILATOR LOUVER Removal

12. REMOVE COWL TOP VENTILATOR LOUVER LH Removal

13. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY Removal

14. REMOVE OUTER COWL TOP PANEL (for TMC Made) Removal

15. REMOVE OUTER COWL TOP PANEL (except TMC Made) Removal

16. REMOVE SUSPENSION TOWER DAMPER ASSEMBLY (w/ Front Strut Bar) Removal

17. DRAIN BRAKE FLUID

18. DISCONNECT CLUTCH TUBE (for Manual Transaxle) Removal

19. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY Removal

20. REMOVE BRAKE PEDAL RETURN SPRING Removal

21. SEPARATE BRAKE MASTER CYLINDER PUSH ROD CLEVIS Removal

22. DISCONNECT VACUUM HOSE

(a) Slide the clip and disconnect the vacuum hose.





23. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY

(a) Remove the vacuum check valve assembly from the brake booster assembly.

24. REMOVE CHECK VALVE GROMMET

(a) Remove the check valve grommet from the brake booster assembly.

25. REMOVE NO. 5 FRONT BRAKE TUBE

(a) Using a union nut wrench (10 mm), disconnect the No. 5 front brake tube from the front brake flexible hose LH.





(b) Remove the grommet and No. 5 front brake tube from the body.





26. REMOVE BRAKE BOOSTER ASSEMBLY

(a) Disengage the 2 clamps and separate the brake lines from the body.





(b) Remove the 4 nuts and brake booster assembly from the body.





NOTICE:
Do not damage the brake lines or fuel lines.

27. REMOVE BRAKE BOOSTER GASKET

(a) Remove the brake booster gasket from the brake booster assembly.

28. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS

(a) Loosen the lock nut and remove the brake master cylinder push rod clevis and lock nut from the brake booster assembly.