Installation (from 07/2011)

TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RECEIVER (for Hatchback): INSTALLATION

1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

(a) Connect the connector to the tire pressure warning ECU and receiver.

(b) Engage the 2 tabs into the holes to temporarily install the tire pressure warning ECU and receiver.

(c) Install the bolt to install the tire pressure warning ECU and receiver.

Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)

2. INSTALL ROOF SIDE INNER GARNISH LH (for 5 Door)

Installation (from 07/2011)

3. INSTALL ROOF SIDE INNER GARNISH LH (for 3 Door)

Installation (from 07/2011)

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Initialization (from 07/2011).

5. REGISTER TRANSMITTER ID

Registration (from 07/2011)

6. INSPECT TIRE PRESSURE WARNING SYSTEM

Test Mode Procedure (from 07/2011)

7. PERFORM INITIALIZATION

Programming and Relearning

8. INSPECT SRS WARNING LIGHT

w/ VSC: Diagnosis System (from 07/2011)

w/o VSC: Diagnosis System (from 07/2011)