Installation (from 07/2011)

SUPPLEMENTAL RESTRAINT SYSTEMS: SEAT POSITION SENSOR (for Hatchback): INSTALLATION

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Airbag System (for Hatchback with VSC/Built-in Type Yaw Rate Sensor).

1. INSTALL SEAT POSITION AIRBAG SENSOR

(a) Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position airbag sensor with the screw.





Text in Illustration





NOTICE:
* If the seat position airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position airbag sensor with a new one.
* When installing the seat position airbag sensor, be careful that the SRS wiring does not interfere with or is pinched between other parts.

HINT
Be sure that the clearance between the seat position airbag sensor and front seat cushion bracket is between 0.6 mm (0.0236 in.) and 2.0 mm (0.0787 in.).

(b) Using a T30 "TORX" socket wrench, tighten the screw to install the seat position airbag sensor.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(c) Make sure that the clearance between the seat position airbag sensor and front seat cushion bracket is between 0.6 mm (0.0236 in.) and 2.0 mm (0.0787 in.).

(d) Connect the connector.

(e) Check that there is no looseness in the installation of the seat position airbag sensor.

2. INSTALL SEAT SLIDE POSITION SENSOR PROTECTOR

(a) Engage the clip to the seat slide position sensor protector.

3. INSTALL FRONT SEAT ASSEMBLY LH

Installation (from 07/2011)

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)