Installation (from 07/2011)

SEAT BELT: FRONT SEAT INNER BELT ASSEMBLY (for Hatchback Driver Side): INSTALLATION

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Airbag System (for Hatchback with VSC/Built-in Type Yaw Rate Sensor). (w/ Front Seat Side Airbag)

NOTICE:
Always use "TORX" socket wrench E10 when removing the front seat.

1. INSTALL FRONT SEAT INNER BELT ASSEMBLY

(a) for 4 Way Seat Type:

(1) Install the front seat inner belt assembly with the bolt.





Text in Illustration





Torque : 41 Nm (420 kgf-cm, 30 ft-lbf)

NOTICE:
Do not place the front seat inner belt over the convex areas of the front seat with frame adjuster.

(2) Engage the clamp.

(3) Engage the 3 clamps.

(4) Connect the seat position airbag sensor.

(b) for 6 Way Seat Type:

(1) Install the front seat inner belt assembly with the bolt.





Text in Illustration





Torque : 41 Nm (420 kgf-cm, 30 ft-lbf)

NOTICE:
Do not place the front seat inner belt over the convex areas of the front seat with frame adjuster.

(2) Engage the 2 clamps.

(3) Engage the 4 clamps.

(4) Connect the seat position airbag sensor.

2. INSTALL SEAT SLIDE POSITION SENSOR PROTECTOR Installation (from 07/2011)

3. INSTALL FRONT SEAT ASSEMBLY

Installation (from 07/2011)

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

5. INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag)

Diagnosis System (from 07/2011)