Removal (from 07/2011)

1NZ-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL (for Hatchback): REMOVAL

1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)

Removal (from 07/2011)

2. REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

Removal (from 07/2011)

3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle) Removal (from 07/2011)

4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)

5. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)





(a) Hold the crankshaft with SST.

SST : 09960-10010

09962-01000

09963-01000

(b) Remove the 6 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly, and front drive plate spacer.





6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)





(a) Hold the crankshaft with SST.

SST : 09960-10010

09962-01000

09963-01000

(b) Remove the 6 bolts and flywheel.





7. REMOVE REAR ENGINE OIL SEAL





(a) Using a knife, cut off the lip of the oil seal.

Text in Illustration





(b) Using a screwdriver with its tip wrapped with tape, pry out the rear engine oil seal.

NOTICE:
After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.