Installation (from 07/2011)

1NZ-FE ENGINE MECHANICAL: FRONT CRANKSHAFT OIL SEAL (for Hatchback): INSTALLATION

1. INSTALL OIL PUMP SEAL

(a) Apply MP grease to the lip of a new oil pump seal.

NOTICE:
Keep the lip free of foreign matter.

(b) Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover edge.





SST : 09223-22010

NOTICE:
* Do not tap the oil seal at an angle.
* Wipe off extra grease from the crankshaft.

HINT
Oil seal tap in depth:

0 to 1.0 mm (0 to -0.04 in.)

2. INSTALL CRANKSHAFT DAMPER SUB-ASSEMBLY Installation (from 07/2011)

3. INSTALL ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH Installation (from 07/2011)

4. INSTALL FAN AND GENERATOR V BELT Installation (from 07/2011)

5. ADJUST FAN AND GENERATOR V BELT Installation (from 07/2011)

6. INSPECT FAN AND GENERATOR V BELT Testing and Inspection

7. INSPECT FOR ENGINE OIL LEAK

8. INSTALL ENGINE UNDER COVER RH

9. INSTALL FRONT WHEEL RH

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)