Installation (from 07/2011)

EXTERIOR PANELS / TRIM: NAME PLATE (for Hatchback): INSTALLATION

1. INSTALL NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE

(a) Clean the attachment surface.

(1) Using an infrared light, heat the double-sided tape remaining on the back door panel.

Heating Temperature





CAUTION:
Do not burn yourself on the hot body panel or with the infrared light.

NOTICE:
Do not heat the vehicle body excessively.

(2) Using a piece of cloth, rub the double-sided tape off the back door panel while it is hot from the infrared light.

NOTICE:
Installing the No. 2 luggage compartment door name plate while any double-sided tape remains on the back door panel may cause adhesion failure. Therefore, completely remove the double-sided tape.

(3) Using a non-residue solvent, clean the attachment surface.

(b) Install a new No. 2 luggage compartment door name plate as shown in the illustration.





Installation Position:





NOTICE:
Install the No. 2 luggage compartment door name plate in an environment where the ambient temperature is over 20°C (68°F). If it is below 20°C (68°F), using an infrared light, heat the back door panel and the No. 2 luggage compartment door name plate to 20 to 30°C (68 to 86°F) and install the No. 2 luggage compartment door name plate.

2. INSTALL NO. 6 BACK DOOR NAME PLATE

(a) Clean the attachment surface.

(1) Using an infrared light, heat the double-sided tape remaining on the back door panel.

Heating Temperature





CAUTION:
Do not burn yourself on the hot body panel or with the infrared light.

NOTICE:
Do not heat the vehicle body excessively.

(2) Using a piece of cloth, rub the double-sided tape off the back door panel while it is hot from the infrared light.

NOTICE:
Installing the No. 6 back door name plate while any double-sided tape remains on the back door panel may cause adhesion failure. Therefore, completely remove the double-sided tape.

(3) Using a non-residue solvent, clean the attachment surface.

(b) Install a new No. 6 back door name plate as shown in the illustration.





Installation Position:





NOTICE:
Install the No. 6 back door name plate in an environment where the ambient temperature is over 20°C (68°F). If it is below 20°C (68°F), using an infrared light, heat the back door panel and the No. 6 back door name plate to 20 to 30°C (68 to 86°F) and install the No. 6 back door name plate.

3. INSTALL SYMBOL EMBLEM

(a) Clean the attachment surface.

(1) Using an infrared light, heat the double-sided tape remaining on the back door panel.

Heating Temperature





CAUTION:
Do not burn yourself on the hot body panel or with the infrared light.

NOTICE:
Do not heat the vehicle body excessively.

(2) Using a piece of cloth, rub the remaining double-sided tape off the back door panel while it is hot from the infrared light.

NOTICE:
Installing the symbol emblem with any double-sided tape remaining on the back door panel may cause adhesion failure. Therefore, completely remove the double-sided tape.

(3) Using a non-residue solvent, clean the attachment surface.

(b) Insert the 2 pins into the back door panel and install a new symbol emblem.





Text in Illustration





NOTICE:
Install the symbol emblem in an environment where the ambient temperature is over 20 °C (68°F). If it is below 20°C (68°F), using an infrared light, heat the back door panel and the symbol emblem to 20 to 30°C (68 to 86°F) and install the symbol emblem.