ABS Control System Malfunction - Vehicle Stability Control System (for Sedan)

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM (for Sedan): 43: ABS Control System Malfunction
43 - ABS Control System Malfunction

DESCRIPTION

This DTC is output when the VSC system detects a malfunction in the ABS control system.





INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration .

PROCEDURE

1. CHECK ABS CONTROL SYSTEM

(a) Clear the DTC .

(b) Turn the ignition switch to ON.

(c) Check if the same DTC is recorded .

Result





B -- REPAIR CIRCUIT INDICATED BY OUTPUT DTC
A -- Continue to next step.

2. RECONFIRM DTC

(a) Turn the ignition switch off.

(b) Clear the DTC .

(c) Start the engine.

(d) Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more for 60 seconds or more.

(e) Check if the same DTC is recorded .

Result





B -- REPLACE BRAKE ACTUATOR ASSEMBLY

A -- CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION)