Installation

U660E AUTOMATIC TRANSAXLE: TRANSMISSION CONTROL CABLE ASSEMBLY: INSTALLATION

1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Put the transmission control cable assembly into the body.

(b) Turn over the carpet and install the transmission control cable assembly with the 2 bolts.

Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)

(c) Install the transmission control cable assembly to the control shaft lever with the nut.

Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)

(d) Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.

(e) If the lock piece is engaged, slide the slider of the transmission control cable in the direction indicated by the arrow and pull the lock piece outward.





Text in Illustration





NOTICE:
Check that the lock piece is not engaged.

(f) Connect the transmission control cable assembly to the transmission floor shift assembly.





Text in Illustration





NOTICE:
* Securely engage the claws.
* Check that the lock piece is pulled up.

(g) Push the lock piece into the adjuster case.





Text in Illustration





NOTICE:
* Check that the park/neutral position switch and the shift lever are in neutral.
* Securely push in the lock piece until the slider lock is engaged.

2. INSTALL NO. 1 AIR CLEANER INLET Installation

3. INSTALL AIR CLEANER CASE Installation

4. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE Installation

5. INSTALL NO. 2 AIR CLEANER INLET Installation

6. INSTALL COOL AIR INTAKE DUCT SEAL Installation

7. INSTALL CENTER AIR BAG SENSOR ASSEMBLY Installation

8. INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONER UNIT ASSEMBLY

Installation

9. INSPECT SHIFT LEVER POSITION Adjustments

10. ADJUST SHIFT LEVER POSITION Adjustments