Installation

SUSPENSION: REAR STABILIZER BAR: INSTALLATION

1. INSTALL REAR STABILIZER BUSHING

(a) Install the 2 rear stabilizer bushings to the outside of the stopper ring on the stabilizer bar as shown in the illustration.





2. INSTALL NO. 2 REAR STABILIZER BAR BRACKET

(a) Install the No. 2 rear stabilizer bar bracket.

3. INSTALL NO. 1 REAR STABILIZER BAR BRACKET

(a) Install the No. 1 rear stabilizer bar bracket.

4. INSTALL REAR STABILIZER BAR

(a) Install the rear stabilizer bar with the 2 bolts. (LH Side)





Torque : 31 Nm (316 kgf-cm, 23 ft-lbf)

(b) Install the rear stabilizer bar with the 2 bolts. (RH Side)





Torque : 31 Nm (316 kgf-cm, 23 ft-lbf)

5. INSTALL REAR STABILIZER LINK ASSEMBLY LH

(a) Connect the rear stabilizer link assembly LH with the nut.





Torque : 39 Nm (400 kgf-cm, 29 ft-lbf)

HINT
If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud.

6. INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT
Perform the same procedures as for the LH side.

7. INSTALL CENTER EXHAUST PIPE ASSEMBLY Installation

8. INSTALL REAR WHEELS

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

9. INSPECT FOR EXHAUST GAS LEAK Installation