Installation

SEAT BELT: CHILD RESTRAINT SEAT ANCHOR BRACKET: INSTALLATION

1. INSTALL CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET

(a) Install the child restraint seat tether anchor bracket with the bolt.

Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)





2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY

(a) Connect the connector.





(b) Engage the 5 claws and the 4 clips and install the package tray panel assembly.

(c) Engage the 4 claws and install the rear seat shoulder belt cover.





(d) Engage the 4 claws and the rear seat shoulder belt cover.





HINT
Use the same procedures for the RH side and LH side.

(e) Install the rear seat inner w/ center belt assembly RH with the nut.





Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

NOTICE:
* Do not overlap the anchor part of the rear belt and the protruding parts of the rear seat adjuster.
* Make sure arrow is pointing towards the front of the vehicle.

(f) Install the rear seat belt assembly outer with the bolt.





Torque : 42 Nm (428 kgf-cm, 31 ft-lbf)

NOTICE:
Do not overlap the anchor part of the rear belt and the protruding parts of the rear seat adjuster.

HINT
Use the same procedures for the RH side and LH side.

(g) Check if the ELR locks.

NOTICE:
The check should be performed with the outer belt assembly installed.

(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.

If operation is not as specified, replace the belt assembly.

3. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH Installation

4. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH Installation

5. INSTALL REAR SEATBACK ASSEMBLY RH Installation

6. INSTALL REAR SEATBACK ASSEMBLY LH Installation

7. INSTALL REAR SEAT CUSHION ASSEMBLY

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

9. PERFORM INITIALIZATION

HINT
Repair Instruction - Initialization

10. INSPECT SRS WARNING LIGHT

HINT
Diagnosis System