Installation

SUPPLEMENTAL RESTRAINT SYSTEM: FRONT SEAT SIDE AIRBAG ASSEMBLY (for Power Seat): INSTALLATION

1. INSTALL FRONT SEAT SIDE AIRBAG ASSEMBLY

CAUTION:
* The nuts must not be reused.
* Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.
(a) Install the front seat side airbag assembly with 2 new nuts.





Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

(b) Engage the clamp to connect the wire harness.





(c) Connect the 4 wire harness clamps to under the seat.

2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD Reassembly

3. INSTALL FRONT SEAT HEADREST SUPPORT RH Reassembly

4. INSTALL FRONT SEAT HEADREST SUPPORT LH Reassembly

5. INSTALL FRONT SEATBACK BOARD COVER SUB-ASSEMBLY Reassembly

6. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY Reassembly

7. INSTALL FRONT SEAT ASSEMBLY Installation

8. INSTALL REAR INNER TRACK BRACKET COVER Installation

9. INSTALL REAR OUTER TRACK BRACKET COVER Installation

10. INSTALL FRONT INNER TRACK BRACKET COVER Installation

11. INSTALL FRONT OUTER TRACK BRACKET COVER Installation

12. INSTALL FRONT SEAT HEADREST ASSEMBLY

13. INSPECT POWER SEAT CONTROL SYSTEM Installation

14. INSPECT SEAT HEATER SYSTEM (w/ Seat Heater System) Installation

15. INSPECT SRS WARNING LIGHT Installation