Installation

2GR-FE EMISSION CONTROL: CANISTER: INSTALLATION

1. INSTALL CHARCOAL CANISTER ASSEMBLY

(a) Install the 2 bolts, clip and charcoal canister.

Torque : 36 Nm (367 kgf-cm, 27 ft-lbf)

(b) Connect the purge line hose to the charcoal canister.

(c) Connect the wire harness clamp.

(d) Connect the vapor pressure sensor connector.

(e) Connect the charcoal canister filter sub-assembly to the charcoal canister.

(f) Connect the fuel tank vent hose to the charcoal canister.

2. INSTALL FUEL TANK ASSEMBLY Installation

3. INSTALL PARKING BRAKE CABLE ASSEMBLY NO.3 Installation

4. INSTALL PARKING BRAKE CABLE ASSEMBLY NO.2 Installation

5. INSTALL EXHAUST PIPE ASSEMBLY CENTER

6. CONNECT FUEL PUMP TUBE SUB-ASSEMBLY

7. ADD FUEL

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

9. CHECK FOR FUEL LEAKS

10. INSPECT FOR EXHAUST GAS LEAK

11. INSTALL REAR FLOOR SERVICE HOLE COVER

12. INSTALL REAR SEAT CUSHION ASSEMBLY