Removal

PARKING BRAKE: PARKING BRAKE PEDAL: REMOVAL

1. PRECAUTION

CAUTION:
Be sure to read the "PRECAUTION" thoroughly before servicing Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE SEAT TRACK BRACKET COVER OUTER FRONT LH Removal

4. REMOVE SEAT TRACK BRACKET COVER INNER FRONT LH Removal

5. REMOVE FRONT SEAT TRACK COVER LH REAR OUTER Removal

6. REMOVE REAR SEAT TRACK BRACKET COVER INNER LH Removal

7. REMOVE FRONT LH SEAT ASSEMBLY Removal

8. REMOVE FRONT DOOR SCUFF PLATE LH Removal

9. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH Removal

10. REMOVE INSTRUMENT SIDE PANEL LH Removal

11. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER LH Removal

12. REMOVE INSTRUMENT PANEL AIR BAG ASSEMBLY LOWER NO.1

13. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

14. REMOVE POSITION INDICATOR HOUSING ASSEMBLY Removal

15. REMOVE CONSOLE BOX UPPER

16. REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER

17. REMOVE CONSOLE BOX ASSEMBLY Removal

18. REMOVE CONSOLE BOX FRONT Removal

19. REMOVE CONSOLE BOX DUCT NO.1

20. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY

21. REMOVE SHIFT & SELECT LEVER SUPPORT

(a) Remove the 4 bolts and shift & select lever support from the body.





22. DISCONNECT PARKING BRAKE CABLE ASSEMBLY NO.4

(a) Release the parking brake.





(b) Hold the nut on the parking brake cable assembly No.1 using a wrench. Loosen and disconnect the turnbuckle of the parking brake cable assembly No.4 from the parking brake cable assembly No.1 using a wrench.

(c) Slide the boot as shown in the illustration.





(d) Remove the parking brake cable assembly No.4 from the parking brake equalizer as shown in the illustration.





23. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY

(a) Remove the clip and separate the parking brake cable assembly No.1 from the cable support bracket.





(b) Remove the bolt, 3 nuts and clamp, and separate the parking brake cable assembly No.1 from the body.

(c) Disconnect the connector.





(d) Remove the bolt, 2 nuts and parking brake control pedal assembly from the body.