Reassembly

BRAKE: BRAKE PEDAL: REASSEMBLY

1. INSTALL BRAKE PEDAL PAD

2. INSTALL BRAKE PEDAL SUB-ASSEMBLY

(a) Install 2 new brake pedal bushes and the collar to the brake pedal sub-assembly.





HINT
Apply lithium soap base glycol grease to the parts indicated by arrows.

(b) Install the brake pedal sub-assembly with the bolt, washer and nut.





Torque : 37 Nm (375 kgf-cm, 27 ft-lbf)

3. INSTALL STOP LIGHT SWITCH ASSEMBLY

(a) Install the stop light switch mounting adjuster.

(b) Insert the stop light switch assembly until the body hits the cushion.

(c) Make a quarter turn clockwise to install the stop light switch assembly.

(d) Connect the stop light switch connector.

NOTICE:
* When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.
* The turning torque for installing the stop light switch assembly

Torque : 1.5 Nm (15 kgf-cm, 13 in-lbf) or less

HINT
After adjusting the brake pedal height, adjust the stop light switch assembly.