Removal

BRAKE CONTROL: BRAKE ACTUATOR: REMOVAL

1. DRAIN BRAKE FLUID

NOTICE:
Wash brake fluid off immediately if it adheres to any painted surface.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE BRAKE ACTUATOR WITH BRACKET

(a) Using SST, disconnect the 6 brake tubes from the actuator with bracket.





SST : 09023-00101

(b) Use tags or make a memo to identify the reconnection points.





(c) Pull the lock lever upward.





(d) Disconnect the actuator connector.

(e) Remove the 3 bolts and the actuator with bracket.





NOTICE:
Do not damage the brake tubes and wire harness.