Installation

U250E AUTOMATIC TRANSMISSION / TRANSAXLE: TRANSMISSION WIRE: INSTALLATION

1. INSTALL TRANSMISSION WIRE

(a) Coat a new O-ring of the transmission wire connector with ATF WS and install it to the transmission wire.





(b) Install the transmission wire with the bolt.





Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(c) Connect the transmission wire connector.

2. CONNECT TRANSMISSION WIRE

(a) Coat the O-ring of the ATF temperature sensor with ATF WS.





(b) Install the ATF temperature sensor with the lock plate and bolt.

Torque : 6.6 Nm (67 kgf-cm, 58 in-lbf)

(c) Connect the 7 shift solenoid valve connectors.

3. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

(a) Install the 2 magnets in the oil pan.





(b) Apply adhesive or equivalent to the 18 bolts.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

(c) Using a new gasket, install the oil pan to the transaxle case with the 18 bolts.





Torque : 7.8 Nm (80 kgf-cm, 69 in-lbf)

NOTICE:
Since the bolts should be seal bolts, apply adhesive to the bolts and tighten them within 10 minutes of application.

4. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY Installation

5. INSTALL BATTERY CARRIER Installation

6. INSTALL BATTERY Installation

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. INSTALL ENGINE UNDER COVER LH

9. ADD AUTOMATIC TRANSAXLE FLUID

10. INSPECT TRANSAXLE FLUID LEVEL Procedures