Installation

CLUTCH: CLUTCH ACCUMULATOR: INSTALLATION

1. INSTALL CLUTCH ACCUMULATOR ASSEMBLY

(a) Install the clutch accumulator assembly with the 3 bolts.





Torque : 19 Nm (192 kgf-cm, 14 ft-lbf)

2. CONNECT CLUTCH LINE

(a) with Clutch Orifice Assembly

(1) Temporarily tighten the clutch line (A).





(2) Install the clutch hose with a new clip (B).

(3) Temporarily tighten the clutch orifice assembly with the 2 bolts (C).

(4) Using a union nut wrench (10 mm), install the 2 clutch lines (A, D).

without a union nut wrench - Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)

with a union nut wrench - Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)

NOTICE:
* Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
* This torque value is effective when the union nut wrench is parallel to the torque wrench.

(5) Tighten the clutch orifice assembly with the 2 bolts (C).

Torque : 19 Nm (192 kgf-cm, 14 ft-lbf)

(b) without Clutch Orifice Assembly

(1) Temporarily tighten the clutch line (A).





(2) Install the clutch hose with a new clip (B).

(3) Temporarily tighten the clump of clutch line with the bolt (C).

(4) Using a union nut wrench (10 mm), install the 2 clutch lines (A, D).

without a union nut wrench - Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)

with a union nut wrench - Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)

NOTICE:
* Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
* This torque value is effective when the union nut wrench is parallel to the torque wrench.

(5) Tighten the clump of clutch line with the bolt (C).

Torque : 19 Nm (192 kgf-cm, 14 ft-lbf)

3. FILL BRAKE FLUID RESERVOIR Service and Repair

4. BLEED CLUTCH LINE Procedures

5. INSPECT FLUID LEVEL Testing and Inspection

6. INSPECT FOR FLUID LEAK

HINT
Check for leaks in the clutch system.

7. INSTALL INLET AIR CLEANER ASSEMBLY Installation

8. INSTALL FRONT FENDER APRON SEAL LH

9. INSTALL ENGINE UNDER COVER LH