Neutral Safety Switch: Adjustments

U760E AUTOMATIC TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: ADJUSTMENT

1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Remove the control shaft lever.

HINT
Removal

(b) Loosen the 2 bolts of the park/neutral position switch.

(d) Hold the park/neutral position switch in position and tighten the 2 bolts.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

NOTICE:
After installing the park/neutral position switch, confirm that the 2 protrusions on the switch are aligned.

(e) Install the control shaft lever.

HINT
Installation

(f) After the adjustment, perform the switch operation check Initial Inspection and Diagnostic Overview.