Installation

SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR: INSTALLATION

1. INSTALL REAR AIRBAG SENSOR

(a) Check that the ignition switch is off.

(b) Check that the battery negative (-) cable is disconnected.

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

(c) Install the rear airbag sensor with the bolt.





Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

NOTICE:
* If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
* When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(d) Check that there is no looseness in the installation parts of the rear airbag sensor.

(e) Connect the connector.

2. INSTALL REAR SEATBACK ASSEMBLY (for Fixed Seat Type) Installation

3. INSTALL REAR SEAT HEADREST ASSEMBLY CENTER (for Fixed Seat Type)

4. INSTALL REAR SEAT HEADREST ASSEMBLY (for Fixed Seat Type)

5. INSTALL RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY (for Reclining Seat Type) Reassembly

6. INSTALL REAR SIDE SEAT BACK ASSEMBLY (for Fold Down Seat Type) Installation

7. INSTALL ROOF SIDE INNER GARNISH (for Fold Down Seat Type) Installation

8. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP (for Reclining Seat Type)

9. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP (for Fold Down Seat Type)

10. INSTALL REAR DOOR SCUFF PLATE (for Reclining Seat Type) Installation

11. INSTALL REAR DOOR SCUFF PLATE (for Fold Down Seat Type) Installation

12. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type) Installation

13. INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type) Installation

14. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) Installation

15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

16. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System for TMC made, Diagnosis System except TMC made).