Installation

2AR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR





(a) Apply a light coat of engine oil to the O-ring of the sensor.

NOTICE:
Make sure that the O-ring is not cracked or jammed when installing the sensor.

(b) Apply adhesive to 2 or 3 threads of the bolt.





Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.

(c) Install the sensor with the bolt.

Torque : 6.5 Nm (66 kgf-cm, 58 in-lbf)

(d) Connect the sensor connector.

2. INSPECT FOR OIL LEAK

3. INSTALL FRONT FENDER APRON SEAL RH