Room Light Assembly (for Rear)

LIGHTING: ROOM LIGHT ASSEMBLY (for Rear): INSPECTION

1. INSPECT NO. 1 ROOM LIGHT ASSEMBLY (without Sliding Roof)

(a) Measure the resistance according to the value(s) in the table below.





Standard resistance:





If the result is not as specified, repair or replace harness or connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:





If the result is not as specified, repair or replace the harness or connector.

2. INSPECT SPOT LIGHT ASSEMBLY (with Sliding Roof)

(a) Measure the resistance according to the value(s) in the table below.





Standard resistance:

LH Side
RH Side










If the result is not as specified, repair or replace harness or connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

LH Side
RH Side










If the result is not as specified, repair or replace the harness or connector.