Installation (from 12/2010)

U660E AUTOMATIC TRANSAXLE: SHIFT LEVER: INSTALLATION

1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

(a) Connect the 2 connectors.

(b) Install the transmission floor shift assembly with the 4 bolts.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

NOTICE:
Check that the park/neutral position switch and the shift lever are in neutral.

(a) Slide the slider of the transmission control cable in the direction indicated by the arrow and pull the lock piece outward.





Text in Illustration





(b) Connect the transmission control cable assembly to the transmission floor shift assembly.





Text in Illustration





NOTICE:
* Securely engage the claws.
* Check that the lock piece is pulled up.

(c) Push the lock piece into the adjuster case.





Text in Illustration





NOTICE:
* Check that the park/neutral position switch and the shift lever are in neutral.
* Securely push in the lock piece until the slider lock is engaged.

3. INSTALL FRONT CONSOLE BOX Installation (from 12/2010)

4. INSTALL CONSOLE BOX ASSEMBLY Installation (from 12/2010)

5. INSTALL CONSOLE BOX CARPET Installation (from 12/2010)

6. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation (from 12/2010)

7. INSTALL SHIFT LOCK RELEASE BUTTON COVER

(a) Install the shift lock release button cover to the position indicator housing assembly.

8. INSTALL POSITION INDICATOR HOUSING ASSEMBLY Installation (from 12/2010)

9. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation (from 12/2010)

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

11. INSPECT SHIFT LEVER POSITION Adjustment (from 12/2010)

12. ADJUST SHIFT LEVER POSITION Adjustment (from 12/2010)