Diagnosis System

2GR-FE STARTING: SMART KEY SYSTEM: DIAGNOSIS SYSTEM

1. DESCRIPTION

(a) Push button start system data and its Diagnostic Trouble Code (DTCs) can be read in the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use Techstream to check for malfunctions and perform repairs.

2. CHECK DLC3

(a) The ECU uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.









NOTICE:
*Before measuring the resistance, leave the vehicle as it is for at least 1 minute and do not operate the ignition switch, or any other switches or the doors.

(b) If the result is not as specified, DLC3 may have a malfunction. Repair or replace the harness and connector.

HINT
Connect the cable of Techstream to DLC3, turn the ignition switch to the ON position and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.

* If communication is normal when the tester is connected to another vehicle, inspect DLC3 of the original vehicle.
* If communication is still not possible when the tester is connected to another vehicle, the problem may be in the tester itself. Consult the Service Department listed in the tester's instruction manual.

3. INSPECT BATTERY VOLTAGE

(a) Inspect the battery voltage.

Voltage:

11 to 14 V

If voltage is below 11 V, recharge the battery before proceeding.