Removal

BRAKE CONTROL: REAR SPEED SENSOR: REMOVAL

1. REMOVE REAR WHEEL

2. DISCONNECT SKID CONTROL SENSOR WIRE

(a) Disconnect the connector from the skid control sensor.





3. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY LH Removal

4. REMOVE REAR DISC

5. REMOVE REAR AXLE HUB & BEARING ASSEMBLY LH

(a) Remove the 4 bolts and rear axle hub & bearing assembly.





6. REMOVE REAR SPEED SENSOR

(a) Mount the rear axle hub in a vise between aluminum plates.





NOTICE:
Replace the axle hub & bearing assembly if it is dropped or receives a strong shock.

(b) Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments (09521-00010) from SST.

SST : 09520-00031

(c) Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the rear speed sensor from the rear axle hub.

SST : 09520-00031

09520-00040

SST : 09521-00020

SST : 09950-00020

NOTICE:
* If damage is inflicted on the sensor rotor, replace the axle hub & bearing assembly.
* Do not scratch the contact surface of axle hub and speed sensor.