Installation (from 12/2010)

2GR-FE ENGINE CONTROL SYSTEM: KNOCK SENSOR: INSTALLATION

1. INSTALL KNOCK CONTROL SENSOR

(a) Install the 2 knock control sensors with the 2 bolts as shown in the illustration.





Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

(b) Connect the 2 knock control sensor connectors.

2. INSTALL INTAKE MANIFOLD Installation (from 12/2010)

3. INSTALL INTAKE AIR SURGE TANK

4. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

6. ADD ENGINE COOLANT Service and Repair

7. INSPECT FOR COOLANT LEAK Service and Repair

8. INSPECT FOR FUEL LEAK On-Vehicle Inspection (from 12/2010)

9. INSTALL V-BANK COVER SUB-ASSEMBLY Installation (from 12/2010)

10. INSTALL COWL TOP PANEL OUTER Installation (from 12/2010)

11. INSTALL WINDSHIELD WIPER MOTOR & LINK ASSEMBLY

Installation

12. CHECK FUNCTION OF THROTTLE BODY On-Vehicle Inspection