Installation (from 12/2010)

TIRE AND WHEEL: TIRE PRESSURE WARNING RECEIVER (w/ Antenna): INSTALLATION

1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY

(a) Install the tire pressure warning receiver assembly with the bolt.





Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)

(b) Connect the connector.





2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH Installation (from 12/2010)

3. INSTALL REAR SEAT SIDE GARNISH LH

4. INSTALL REAR DOOR SCUFF PLATE LH

5. INSTALL REAR SEATBACK ASSEMBLY LH Installation

6. INSTALL REAR SEATBACK LOCK COVER CAP

7. INSTALL REAR SEAT HEADREST ASSEMBLY

8. INSTALL REAR SEAT CUSHION ASSEMBLY

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

10. INSPECT TIRE PRESSURE WARNING SYSTEM

HINT
Test Mode Procedure (from 12/2010)