Reassembly

LIGHTING: HEADLIGHT ASSEMBLY: REASSEMBLY

1. INSTALL SIDE MARKER LIGHT BULB

(a) Install the side marker light bulb to the side marker light socket.

(b) Turn the side marker light bulb and side marker light socket in the direction indicated by the arrow shown in the illustration and install them as a unit.





2. INSTALL FRONT TURN SIGNAL LIGHT BULB

(a) Install the front turn signal light bulb to the front turn signal light socket.

(b) Turn the front turn signal light bulb and front turn signal light socket in the direction indicated by the arrow shown in the illustration and install them as a unit.





3. INSTALL AUXILIARY LIGHT BULB

(a) Install the auxiliary light bulb to the headlight socket.

(b) Turn the auxiliary light bulb and headlight socket in the direction indicated by the arrow shown in the illustration and install them as a unit.





4. INSTALL NO. 2 HEADLIGHT BULB (for Halogen Headlight)

(a) Turn the No. 2 headlight bulb in the direction indicated by the arrow shown in the illustration to install it.





NOTICE:
Do not touch the bulb glass.

5. INSTALL DISCHARGE HEADLIGHT BULB (for HID Headlight)

(a) Lock the set spring to install the discharge headlight bulb as shown in the illustration.





NOTICE:
Do not touch the bulb glass.

6. INSTALL LIGHT CONTROL ECU (for HID Headlight)

(a) Turn the socket of the light control ECU in the direction indicated by the arrow shown in the illustration to connect it.





NOTICE:
* Check that the O-ring is installed on the light control ECU.
* Check that the O-ring is not damaged or contaminated with foreign matter. If there is any damage, replace the O-ring with a new one.
* Do not pull the light control ECU with the socket connected.

(b) Check that the red line on the output harness is not twisted and store the harness in the headlight assembly securely so that the output harness is not pinched.

Text in Illustration





(c) Turn the light control ECU in the direction indicated by the arrow shown in the illustration until the lock marks are aligned to install it.





Text in Illustration





NOTICE:
* To prevent incomplete installation, make sure to fully push in and turn the light control ECU until the lock marks are aligned.
* Do not apply excessive force using a tool.

7. INSTALL NO. 1 HEADLIGHT BULB (for Halogen Headlight)

(a) Turn the No. 1 headlight bulb in the direction indicated by the arrow shown in the illustration to install it.





NOTICE:
Do not touch the bulb glass.

8. INSTALL NO. 1 HEADLIGHT BULB (for HID Headlight)

(a) Turn the No. 1 headlight bulb in the direction indicated by the arrow shown in the illustration to install it.





NOTICE:
Do not touch the bulb glass.

(b) Connect the connector.





9. INSTALL HEADLIGHT SOCKET COVER (for HID Headlight)

(a) Turn the headlight socket cover in the direction indicated by the arrow shown in the illustration to install it.