Installation (to 12/2010)

CRUISE CONTROL: CRUISE CONTROL MAIN SWITCH: INSTALLATION

1. INSTALL CRUISE CONTROL MAIN SWITCH

(a) Install the cruise control main switch assembly with the 2 screws.

Torque : 2.35 Nm (24 kgf-cm, 21 in-lbf)

(b) Connect the connector.

2. INSTALL STEERING PAD Installation (to 12/2010)

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

4. PERFORM INITIALIZATION

NOTICE:
Some systems need initialization when disconnecting the cable from the negative battery terminal Repair Instruction - Initialization.

5. INSPECT STEERING PAD Installation (to 12/2010)

6. INSPECT SRS WARNING LIGHT

Check Mode Procedure