Operation Check

DOOR LOCK: WIRELESS DOOR LOCK CONTROL SYSTEM: OPERATION CHECK

1. CHECK WIRELESS DOOR LOCK CONTROL SYSTEM

HINT
* The following switches built into the door control transmitter send radio waves to the door lock control.
* The operational range must be taken into account during checks.

(a) Establish conditions that allow the wireless control function to be operated successfully.

(b) Check these basic functions.

(1) Check that all the doors lock when the lock switch is pressed.

(2) Check that all the doors unlock when the unlock switch is pressed.

(c) Check the panic alarm function.

(1) Check that if the panic switch is held down for 0.8 seconds or more, the theft deterrent alarm function sounds the horn, and flashes the headlights, tail lights and hazard warning lights for 27.5 seconds. And with the theft alarm function active, check if pressing any switch on the transmitter stops the horn and turns off the headlights, tail lights and hazard warning lights.

(d) Check the automatic lock function.

(1) Check that if all the doors are unlocked with the unlock switch and none of the doors are opened or locked within approximately 30 seconds, the doors automatically re-lock.

(2) Check that if all the doors are unlocked with the unlock switch and a door is opened or locked within approximately 30 seconds, the automatic lock function does not operate.

(e) Check the door ajar warning function.

(1) Check that if a door is open or not completely closed, the doors cannot be locked with the lock switch and the wireless door lock buzzer sounds for about 10 seconds.

(f) Check the room light ON function.

HINT
Move the room light switch to the DOOR position before the check.

(1) Check that the room light comes on simultaneously with the unlocking operation when the unlock switch has been pressed for 1 second.

(2) Check that the room light goes off in approximately 15 seconds if none of the doors is opened after the unlocking operation.

(g) Check the repeat function.

(1) Check that all doors attempt to automatically lock once again 1 second after the lock switch has been pressed while one of the door lock knobs is held in the unlocked position.

(h) Check the answer back function.

(1) When the lock switch is pressed, check that the hazard warning lights flash once and the wireless door lock buzzer sounds once simultaneously with the locking of all the doors.

(2) When the unlock switch is pressed, check that the hazard warning lights flash twice and the wireless door lock buzzer sounds twice simultaneously with the unlocking of all the doors.

(i) Check the switch operation fail-safe function.

(1) Check that the doors cannot be locked by operating a switch while the key is in the ignition key cylinder.

HINT
This check cannot be made when the system is in recognition code registration mode.

(j) Check the chattering prevention function.

(1) Check that the corresponding operation occurs only once, and does not repeat itself while the switch is kept pressed. Check that the corresponding operation is carried out when the switch is operated repeatedly at 1-second intervals.

(k) Check the trunk opener function.

(1) Check that the trunk opens when the trunk opener switch is held down for 0.8 seconds or more.