Audio and Visual System (to 12/2010)

AUDIO / VISUAL: AUDIO AND VISUAL SYSTEM: CB-10-CB-12: System Microcomputer Malfunction
CB-12 - CD-LSI Malfunction

DESCRIPTION





INSPECTION PROCEDURE

HINT
After the inspection is completed, clear the DTCs.

PROCEDURE

1. REPLACE USB DEVICE OR "iPod"

(a) Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

(b) Turn the ignition switch off.

HINT
When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

(c) Turn the ignition switch to ACC.

(d) Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

NEXT -- Continue to next step.

2. CLEAR DTC

(a) Clear the DTCs DTC Check / Clear (to 12/2010).

NEXT -- Continue to next step.

3. RECHECK FOR DTC

(a) Recheck for DTCs and check if the same DTC is output again.

HINT
If DTCs are detected frequently, replace the multi-media interface ECU.

OK:

No DTCs are output.

NG -- REPLACE MULTI-MEDIA INTERFACE ECU Removal (to 12/2010)

OK -- USB DEVICE OR "iPod" WAS DEFECTIVE