Tire Pressure Monitoring (to 12/2010)

TIRE AND WHEEL: TIRE PRESSURE WARNING SYSTEM: C2176/76: Receiver Error
C2176/76 - Receiver Error

DESCRIPTION

When the tire pressure warning ECU is detected to internal data error, DTC C2176/76 is stored.





INSPECTION PROCEDURE

NOTICE:
* When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and note them down before removal.
* It is necessary to perform the initialization Initialization (to 12/2010) after the registration Registration (to 12/2010) of the transmitter IDs into the tire pressure warning ECU if the ECU and/or one of the valve and transmitters have been replaced.

PROCEDURE

1. CHECK DTC OUTPUT (C2176/76)

(a) Clear the DTC DTC Check / Clear (to 12/2010).

(b) Turn the ignition switch off.

(c) Turn the ignition switch on (IG) and check for DTCs DTC Check / Clear (to 12/2010).

OK:

DTC C2176/76 is not output.

NG -- REPLACE TIRE PRESSURE WARNING ECU Removal (to 12/2010)

OK -- END